Product Technical Sheet

It is a self-adhesive waterproofing membrane, resistant to tearing, HDPE coated, applied without hot air welding and torch. It is easy to apply by removing the silicone foil on the bottom surface and provides permanent insulation.

Material Properties
Top Surface: Double Layer Laminated HDPE
Bottom Surface: Silicone Foil
Color: black
Application Temperature: +5 ° C to 35 ° C
Thickness: 1.50 mm
Weight: 2 kg / m2

Foundation and curtain walls, wet areas, retaining walls, horizontal and vertical surfaces, protection and insulation of structures and building elements exposed to leachate, temporary or continuous water pressure, external insulation of water tanks, insulation of basements and tanks, underground garages and parking lots It is used in insulation.

Since it is not a UV resistant product, it should be properly covered after application.

It is easy to prepare and apply. It does not require torch and hot air supply. It fully adheres to the applied surface. It helps to detail solutions. It has crack bridging feature. It provides insulation after application without requiring drying time. It can be applied on vertical and horizontal surfaces, it does not flow.

Surface Preparation
The application surface must be free of strong, dry, clean and loose parts. Spikes on the surface should be rounded with corners spiral stone and deep gaps should be closed with repair mortar. Internal corners, joints of the walls should be chamfered. The application surface should be primed with bitumen primer and application should be started after the primer is completely dry. Surfaces that will decrease the adherence of the material should be roughened.

Product Preparation
The silicone foil on the bottom surface is ready for use after removal.

50 – 100 cm of the membrane is opened and 30-50 cm of the protective paper is peeled and laid. Starting from the middle of the laid membrane, it is ensured that the sticky surface adheres to the floor with the help of a hard roller brush, without any air bubbles. The protective tape, which is left at the front, is pulled from the bottom and the membrane is continued along the line by rolling the membrane. In the next membrane combination, the same processes are continued to make a 10 cm overlap. To ensure a firm and permanent seal, the adhesive part in the overlap area should be pressed very well and adhered very well.

1 m2 / m2

20 m2 in cardboard boxes in rolls.

Its shelf life is 12 months in an unopened and sun-free environment. Attention should be paid to product circulation and delivery should be ensured with the principle of “FIRST INTRODUCING FIRST EXIT”.

Application should not be made while it is raining or potentially raining.
Application should be made to the part of the structure that comes into contact with water.
Attention should be paid to the application temperature, application should be done in the temperature range of + 5 ° C + 35 ° C.
The membrane is not suitable for walking directly on it. It should be protected from direct mechanical effects.
Direct point and line loads should be avoided.
Protection should be provided with materials such as HDPE insulation protection membrane, heat insulation plate placed on it.
On the floor of the balcony, on the roofs and on the roofs, it should be protected by first laying the felt and then pouring round / cornerless gravel on it.

If the product is used outside its intended purpose or the application conditions mentioned above are not observed, BTİ Bitüm Teknik İzolasyon San. ve Dış Tic. Ltd. Ltd. Şti is not responsible.

* For the safety data sheet, please read the QR code in the product technical sheet.

Related Items